FDM 3D printing in one continuous line (vase mode)
Protection
UK registered designs 6404176 to 6404180 and 6404185, granted January 2025
Outcome
A growing family of holders for desks and homes, made to hold whatever you need them to, now and for years.
Soft. Strong. Yours to rearrange.
General
on purpose
Made to hold anything, not one thing
The name is only a suggestion
Modular
any way round
Modules sit in the tray, in any spot
Rearrange them as your desk changes
For years
not one use
Still useful as your life changes
Lasting is the sustainable part
Two directions
BubbleBars started in 2024 with blocks that stack and slide one way, along their ridges. I wanted pieces that could slide two ways, and a grid of bubbles does that: anything resting on it can move either way and still settle into the gaps. The first was a tray for my desk, where pens line themselves up between the bubbles. Then came modules that sit on the tray and hold particular things.
The first prototypes
The first prototypes, in spring 2024, were about the bubbles themselves: how big, how far apart, how round. About ten of them, mostly 3×3 swatches with different fillets, curves and spacing, with the first modules to try on the tray. The phone stand didn't work yet. I was still finding its angle.
April 2024
April 2024
May 2024
May 2024
Strong, with very little plastic
Two rules never changed from the first swatch: one continuous line, which makers call vase mode, and a thick wall, about 1.5 mm wide. Curved walls that meet stiffen each other, so the parts come out strong with very little plastic.
Sticky note holder
Sitting in the tray
The phone stand
The phone stand took the longest. Lean its face too far back and the bubbles at its base run into one another, and the one continuous line can't get round them. So the angle stops where the line still works. Even then, along the bottom edge at the back, where the stand turns inwards, neighbouring bubbles would have merged. There they're cut into crescent moons instead, so each keeps its shape. Look closely at the back and you'll see them.
Sliced two ways
The same phone stand, sliced two ways. Traditional is how most people would print it: three walls and infill from a 0.4 mm nozzle. One line is how it's designed to be printed: a 0.8 mm nozzle drawing one continuous line from the base to the top. About a third of the time, with two thirds of the plastic.
Pens today. A phone tomorrow. A notebook next year. Still useful.
Phone stand
Holding pens
Tray
Jewellery
Coaster
A bottle and a mug
Notepad stand
Notebooks
A vinyl cover
The range
A tray, two coasters, and stands for phones, napkins, notepads and sticky notes, with more to come. The laptop stand is next: the same bubble scaled up, a stand that turns in its base. Step through them on the viewer, with its arrows or its name, to watch each one print.
Nothing in the bin
One BubbleBar is just for the studio: a big bin for the bits of purge and PLA waste that printing makes, the last one on the viewer. I keep that waste low, so it fills slowly, but none of it is thrown away. Every bit is sent for recycling. It's bubbles all round rather than straight walls: walls of bubbles come out stronger, and it suits the studio. A ridged wall would have printed a little more efficiently, but this was far more fun.