Skip to content

All projects

Chopping Board Holder For a motorhome

  • Recycled PLA
Our part
Designed to fit one chopping board, and printed
Process
FDM 3D printing on a Bambu Lab A1
Outcome
Two mounts that hold the board still on the road

The board in its mounts

Made for one board

A motorhome owner near us wanted somewhere to keep their chopping board: held still on the road, out of the way, and easy to lift out. Not a business, just one person with one board. We designed two mounts around it, a channel for its bottom edge and a clip through its handle, made to its exact shape. We like small jobs like this. If something at home would work better with a part made to fit it, it's worth asking.

Two ways to print it

We design parts so they can print in vase mode: one continuous line, no infill, no supports. These mounts can, on a 0.8 mm nozzle, in about 1 h 11 min for the pair. For a one off job like this one, printing the traditional way is fine too, and that's how the pair in the motorhome was made: a 0.4 mm nozzle, three walls and 25% infill, in 2 h 39 min. Both are here, printing side by side.

Either way works

For a single pair, the two come out close: about the same plastic, the vase mode pair only a gram or two heavier. The walls were already designed thin and even, so the traditional print wasn't carrying much extra to begin with. Vase mode would still be the better print. Its one wall is laid thicker, in a single unbroken line, so the mounts come out stronger. And it takes under half the time, which means less wear on the printer and less electricity for every pair.

Nearly the same plastic.
Under half the time.

Top mount

Bottom mount

In the motorhome

Designed thin. Printed either way.

Built to last.
Designed to return.
Back to the start

Chopping Board Holder