One parametric dispenser that resizes for any brand's products in a few numbers, printed to order in recycled PLA.
Mini dispenser
The brief
Period care brands sell dispensers to workplaces, venues and campuses, then keep them stocked with their own pads and tampons. Eco Dispense makes those dispensers, printed to order, in each brand's own size and look. Their existing model worked, but it wasn't built to change. Every brand's pads and tampons are a different size, and fitting the channels inside to a new one meant remodelling by hand each time.
One model, every brand
So we started again, from scratch, with one fully parametric model in SolidWorks. A few numbers set the channels inside to fit any brand's pads and tampons, and the height, width and depth of the body, so a dispenser can hold more. Change them and the rest follows: the doors, the hinges, the mount and the cutouts. The same file makes a mini, a large and an extra large dispenser: up to 300 mm tall, 248 mm wide and 95 mm deep, with corners from 1 to 20 mm round, custom cutouts in the front, a window to see when it needs refilling, an optional lock and full colour printed graphics.
One model. Every brand. Straight to print.
Taller
From behind
Mount frame
Door hinge
Printed in recycled PLA
Every part is printed in recycled PLA. The body comes off a 1.4 mm nozzle in thick 0.6 mm layers with wide walls, so a mini body takes under three hours. The doors and the mount frame are finer, from a 0.6 mm nozzle. A mini is a body, two doors and a mount frame: about 450 g in all. Pick a part from the name on the viewer to watch it print.
Made for the wall
The hardest part to get right was the mount: slim enough to sit hidden behind the dispenser, and strong enough that the dispenser can't be pulled off. The frame goes on the wall first, with four screws or five 3M pads, whichever the wall allows. The dispenser slides down over it until it clicks. For busier places there's an optional lock. A hole through the top of the body takes a key lock that holds it to the frame, so nobody can slide it up and take it away.
Mount frame
Slide down, click
Screw or stick. Slide down. Click. Refill from behind.
Refilled from behind
The doors are at the back, hinged at the bottom. Lift the dispenser off its frame, open them, load the pads and tampons, and they click shut. Open, they rest level, out of the way.
Doors open
Pads and tampons
The feel of the slot
Getting products out of the front took the most refining. Too loose and they fall out; too tight and taking one tears the packaging. The slots were tuned until each comes out cleanly, one at a time.
Why print them
Most dispensers like these are stainless steel or moulded ABS plastic, made in big runs to one size. Printing them means each brand gets its own size, cutouts and graphics with no tooling, made to order rather than stocked, in recycled PLA that can be ground down and recycled again.
Where they went
We made dispensers this way for four period care brands, in mini, large and extra large sizes, and they're now installed in many places. The work was done while Dhruv was at Batch.Works, who produced the dispensers, and it's shown here with their permission.
Designed to adapt.
Built to last. Designed to return. Back to the start